Lash lift application:

THIS APPLICATION GUIDE IS BASED ON USING AIR LIFT PRODUCTS 

STEP 1 – Star timer. Use a Micro fibre brush to apply a thin layer of AIR LIFT Lifting lotion from lash root (CAUTION: leave a 1-2mm gap) and apply up ¾ of the lashes. Carefully moving slowly from inner corner to outer corner, evenly distributing the lotion.

TIP – DO NOT apply the lotion on the tips on the eyelashes. This may cause damage and over processing. Be careful NOT to put a thick layer of lotion as it may run into he clients eye. DO NOT cover lotion with tape/clingfilm/towel etc.

CAUTION: Timer needs to be set BEFORE you start to apply the lotion, both AirLIft lotions are fast developing and over-processing can easily occur if not following instructions.

RECOMMNEDED DEVLOPMENT TIMES

To remove the lifting lotion, first use the Finishing Blade on the Air Lift PULL back tool to remove most of the product. Then gently remove any trace using a dry cotton bud – then a wet one – then a dry one again. Do not make the wet cotton bud too wet – a damp one will do the job and too much water may dissolve the gel. Please take time and ensure all lotion has been fully removed.

Leaving any lotion will cause over-processing and damage clients natural lashes.

STEP 2 – Repeat this technique using the Air Lift setting lotion. Leaving on for the recommended time. Setting lotion also needs to be completely removed. Follow instructions above.

STEP 3 – You now will tint the eyelashes, mixing your developer and tint, mix 2-part developer to 1 part tint. Mix the tint together so it looks like butter cream. Then apply the tint all over the lashes with either a microfibre brush or cotton bud.

TINT PROCESSING TIMES